NOTE: The vinyl patch is often wrapped around the tube of glue. Be careful not to throw it away!
Waterbed Vinyl Repair Kit
You can use this waterbed vinyl repair kit on any vinyl products.
Creates a bond in seconds
Once applied the patch is stronger then the waterbed mattress
You have multiple patches included. If you cut the patches the size of quarters, then you can get about 5 patches. There is a lot of glue that comes with the package. If you run out of patches, you can use the flap that is usually hanging around the valve of your mattress.
Instructions are inlcuded.
Here are some brief instructions that might be of help. - 1. Cut a patch the size of a quarter. Make sure that the patch is round and doesn't have any sharp edges. Using your finger, drip some glue around the hole and smear it around slightly bigger then the patch itself. Drip some glue on one side of the patch and make sure all of it is covered with the glue. Quickly place the patch (glue side down) on top of the hole so that the glue meets the glue. Press down and make sure that none of the patch curls up. Once the patch is flat, drip some more glue on top and around the edge of the patch. Blow on the glue to have it set faster. The glue on your finger will rub off easily.
Product includes a tube of vinyl glue and a roll of vinyl.